Diameters / Packaging
|
Diameters |
11.3 KG SPOOL |
|---|---|
| 1.6 mm | ED031134 |
DETAILS
LINCORE® T & D ideal for build-up of tool steel dies and edges, or applying wear resistance surface on carbon and low alloy steels delivers a deposit similar to H12 tool steel with a Rockwell Hardness range of 48- 55(HRC) to produces a crack-free wear resistant tool steel.
Features
- Delivers a deposit similar to H12 tool steel
- For build-up of tool steel dies and edges, or applying wear resistance surface on carbon or low alloy steels
- To be used on carbon steel, low alloy steel or tool steel
Typical Applications
- Punch dies
- Shear blades
Welding Positions
- Flat/Horizontal
Service Information
You May Also Need
BEFORE USE, READ AND UNDERSTAND THE SAFETY DATA SHEET (SDS) FOR THIS PRODUCT AND SPECIFIC INFORMATION PRINTED ON THE PRODUCT CONTAINER. SDS Search page
MECHANICAL PROPERTIES
| Classification | Hardness Rockwell C |
|---|---|
| Typical Result | 48-55 |
| Typical Result, Tempered | 55-65 |
DEPOSIT COMPOSITION
| Classification | %Al | %C | %Cr | %Mn | %Mo | %Si | %W |
|---|---|---|---|---|---|---|---|
| Typical Result | 1.8 | 0.65 | 7.0 | 1.5 | 1.4 | 0.8 | 1.6 |
TYPICAL OPERATING PROCEDURES
| Diameter | Polarity |
ESO
mm (in.) |
Wire Feed Speed
m/min (in/min) |
Voltage
volts |
Approx. Current
amps |
Deposition Rate
kg/hr (lb/hr) |
|---|---|---|---|---|---|---|
| 1/16 in (1.6 mm) | DC+ | 32 (1 1/4) | 3.8 (150) | 22 | 170 | 2.4 (5.4) |
| 1/16 in (1.6 mm) | DC+ | 32 (1 1/4) | 5.1 (200) | 23 | 210 | 3.6 (7.9) |
| 1/16 in (1.6 mm) | DC+ | 32 (1 1/4) | 6.4 (250) | 24 | 250 | 4.1 (8.9) |
| 1/16 in (1.6 mm) | DC+ | 32 (1 1/4) | 7.6 (300) | 25 | 270 | 4.9 (10.8) |
| 1/16 in (1.6 mm) | DC+ | 32 (1 1/4) | 8.9 (350) | 26 | 300 | 5.4 (12.0) |
NOTES
| Note |
|---|
| Minimum preheat and interpass temperatures of 315°C (600°F) are essential for crack-free welding on mild steel or low alloy steel. For crack-free welding on tool steel parts, preheat of 538°C (1000°F) or higher may be necessary. |
| After welding, very slow cooling to 121°C (250°F) is usually required. This can be followed by post-weld heat treating at 538° - 593°C (1000° - 1100°F) to develop maximum hardness |