10 lb plastic spool Pipeliner 70S-G MIG wire

Diameters / Packaging

Diameters
10 LB SPOOL
30 LB SPOOL
0.045 IN ED030904 ED030905

Pipeliner® 70S-G

MIG (GMAW) Wire | ED030904

AWS: ER70S-G

Pipeliner® 70S-G from Lincoln Electric has a low silicon level for unblemished welds with less clean up required.

DETAILS

Has a low silicon level for unblemished welds with less clean up required. Provides good back bead shape when using the STT® process on root passes. Recommended for root pass welding of up to X100 grade pipe as well as hot, fill and cap pass welding of up to X70 grade pipe.

Features

  • Root pass capability up to X100 and hot, fill and cap pass up to X70 grade pipe
  • Low silicon level for minimal clean-up
  • Good back bead shape on STT® root passes
  • Q2 Lot® - Certificate showing actual deposit chemistry available online
  • ProTech® packaging system

Disclaimers

Warning -

Cancer and Reproductive Harm -

www.P65Warnings.ca.gov

You May Also Need

BEFORE USE, READ AND UNDERSTAND THE SAFETY DATA SHEET (SDS) FOR THIS PRODUCT AND SPECIFIC INFORMATION PRINTED ON THE PRODUCT CONTAINER. SDS Search page

See test result disclaimer

CONFORMANCE

CONFORMANCES SPECIFICATION CLASSIFICATION
AWS AWS A5.18 ER70S-G

MECHANICAL PROPERTIES

Classification Shielding Gas Polarity Yield Strength @ 0.2% Offset
MPa (ksi)
Tensile Strength
MPa (ksi)
Elongation
%
ER70S-G Requirement Not Specified Info. Only 400 (58) min. 480 (70) min. 22 min.
Typical Result, As-welded 100% CO2 DC+ 400-450 (58-65) 500-550 (73-79) 23-29

WIRE COMPOSITION

Classification %Al %C %Cr %Mn %Mo %Ni %P %S %Si %Ti %V %Zr %Total Cu
Typical Result <0.00 0.08-0.09 0.02-0.04 1.16-1.25 0.01 0.03 0.004-0.010 0.020-0.025 0.51-0.60 <0.00 <0.005 <0.001 0.15-0.23

TYPICAL OPERATING PROCEDURES

Diameter Polarity CTWD
mm (in.)⁽¹⁾
Wire Feed Speed
m/min (in/min)
Voltage
volts
Approx. Current
amps
Melt-off Rate
kg/hr (lb/hr)
1.1 mm (0.045 in) DC+ 12-19 (1/2-3/4) 3.2-12.7 (125-500) 19-30 145-340 1.5-6.0 (3.4-13.2)

NOTES

Note
⁽¹⁾ CTWD (Contact Tip to Work Distance). Subtract 1/4 in. (6.4 mm) to calculate Electrical Stickout.